Bitcraze Forums

@leland: I am sry for you, but its likely that you seem to be also a victim of a broken MPU6050 chip.. Seem to get a serious problem for the cf

tobias wrote:Then please open a support case at Seeedstudio.

- The zaccelAverage should be determined during calibration at startup. It is exactly what the accelerometer Z axis delivers on a motionless unit. Agree, i was thinking of the same! Additionaly the thrust that is applied to the cf manualy when the hover mode is activated during the flight should be...

phiamo wrote:either the fly drops like a stone or it raises

Yeah sadly this is what I got most of the time.. one time it was actualy quite stable with some ocilations getting bigger after some time. Will have a look to the values a bit closer next time.

atomicdog wrote:You should now see extra icons on each post that allows you to moderate.

nope..

@ vandermr, sorry I did not wat to insult you in any way. I agree that to solder the diode will be tricky, but it might not be impossible to fix your board. First I would try to clean everything., than try with a THIN tip and low temeratures to resolder the diode. If this is successfull it would be ...

So it seems there is still a usb3 problem in the newest firmware for macs? Can anyone confirm this?

Ok resolderd the moder wire and everthing works ok.. I have the feeling that the charching/software issue had something to to with the losse motor wire solder point. Maby this created a short somewhere?

Wow.. seems like you have used a way too big tip with way to much power. Actually the soldering of those thing are not too difficult, have you watched the assembly video, before? I mean I am a softwware engeneer, and do soldering very rarely (every few years), but didn't had much trouble. Just used ...

atomicdog is right, you definatly have the 10 dof version and your board looks exectly like mine..

hmm.. no, only you guys are mods (and admistrators of cause), see here