Bitcraze Forums

Of course.
Looking forward to your quadcopter.

As the video shown, it can fly. But one problem is: I can't find a good place to play it. This means it's very hard to me to do the following test. So my plan is: setup a 250mm quad copter platform which can test in my room. And finish prototype verification on this "small" platform. Then ...

update video
http://v.youku.com/v_show/id_XODM2MTI1Nzc2.html

update balance test bar

Hi, i have three questions about your setup. According to this post http://www.bitcraze.se/2014/03/brushless-driver-for-the-crazyflie/ Is not necessary the resistors to reduce the voltage to 2.8v from ESC's ? And about the brushless driver tag activation on code do you did ? The ESC's have simonK f...

Yes, I planed to use rubber washer between motor and frame. But the other guys said to me, it's not so necessary to do this for this size quadcopter. I also believe it's better to have. But firstly, I need setup the balance testing environment and let it fly. Then I can do other optimizations. I wil...

assembling finish close-up

I'm doing my first big quadcopter using crazyflie to control:

update video
http://v.youku.com/v_show/id_XODM2MTI1Nzc2.html

airframe ESC and brush-less motors propeller assembly drawing crazyflie for control

Hi, I'm do some porting of crazyflie firmware, now the system is online (LEDs work well). On my PC side, it works well with original crazyflie firmware (binary). Client can scan and find my binary (with Keil C compiled), but when I connect to the board. some warning messages and disconnected. error....

You need full version of Keil. And that's why open source projects use GCC and linux environment. (free!)