Bitcraze Forums

I did It ! . changed the Transistor and now the motors work properly. Getting ready for Takeoff

New Lipos Arrived. Selftest of 3 motors worked. Motor M1 spins permanently. i checked the resistances. My results: M2-M4 for blue to yellow i get 10k ohm , and 100ohm from blue to green. For M1 i get 0 Ohm for blue to yellow and 100 ohm for blue to green. I need a new Transistor T_T ?! Any suggestio...

i charged the lipo with 100 mA. At 4.2V i reached the limit. 50 mAh were charged, so about 1/ 3 of lipo capacity. tried to power CF via recharged lipo and it doesnt work. I will buy 3 new lipos. I hope its not a problem with the CF board.

Does the Crazyflie work when running it from the battery? Have you connected to the Crazyflie? If you have you should get flight data information as well. At first Crazyflie did work while running it from the battery. After i had flashed the firmware via bootloader, i tested the motors. everything ...

The battery indicator shows an empty bar. I think i need a new lipo.

Hi Guys, after a first (successful) selftest of the lipo (motors were running), i wanted to charge the lipo via usb. My LED's on status connected are : Blue steady lid, red is blinking at 1 HZ, and green is steady. If i now connect via Crazyflie PC CLient the LEDs change to : Blue steady lid, red st...