Bitcraze Forums

I manually set up the mappings for my controller (Ouya) and now it's working

My console never shows any data at all, but I just noticed that if I set the minimum thrust to 0, and give it anywhere up to 15-16%, all of the motors except M4 spin. So it seems to me that this motor isn't getting enough power. This is the second motor I've had in that position, so I assume it can'...

For some reason, the console tab and toolbox are always empty? Should it show logging from the CF?

I'm also having a problem with M4. It spins, but seemingly not as fast as the others, because there's a huge bias in that direction. Is this a wider problem or just bad luck?

EDIT: my problem was due to bad mappings (using Ouya controller).

ok, so I replaced M4. Spun it up, still the same...... This propeller stops before all the others, though I have replaced both the motor and the prop. And that's the direction the CF flies in (it's the last leg to leave the ground). I updated the firmware, and set the roll trim all the way up to 20,...

I've noticed that when I spin up all the motors for just a moment, that particular motor (M4) is the first to stop after the power is released. So, I'm in the middle of replacing M4, it's kind of tricky, as the solder closed the holes back up after I removed the wires, so now I have to heat the conn...

Hi all, I looked through every post but didn't see anything that matches my problem. When I try to take off, one side of the CF doesn't lift as much as the other sides, so it tilts, then flies fast in that direction. I haven't been able to get it to lift vertically at all. I checked: - that the moto...