Bitcraze Forums

Hi
Because the power switch broke I am using a wire to turn Crazyflie on and off, so I think that the delay is being cause by me not turning power on properly, it takes me a few tries until I see the red led lit then off then back on and flickering I know then that it has connected.
Regards
Rodrigo

Hi Yes the led blinks fast about 5 times per second then it briefly stops and blinks again and so on. Yes I am using the aideck-gap8-examples/examples/other/wifi-img-streamer. Yes I am able to connect and run opencv-viewer.py and the window opens and I can see the images, this part works fine. What ...

Hello Marcus Thank you for your reply, maybe I wasn’t clear in my last reply, I do connect to the WiFi streaming example, the issue is that I find it takes too long to establish a connection, and I have noticed how the red led on the right hand side of camera flashes very bright and fast when it con...

Hello I did what you suggested and I am getting same results, I have to turn wifi off and on, still not connecting as it did before, I don’t know if it is my router or the aideck. What else can you suggest? I tried to flash the esp firmware with cfloader but I get this error: could not save cache, n...

hi marcus here is the output from consle SYS: Crazyflie 2.0 is up and running! SYS: Build 38:2a282b575c25 (2022.03 +38) CLEAN SYS: I am 0x313139313535511300360046 and I have 1024KB of flash! CFGBLK: v1, verification [OK] DECK_CORE: 1 deck(s) found DECK_CORE: Calling INIT on driver bcAI for deck 0 AI...

Hi I am having a problem after running tb make menuconfig I set ssid and password save it and reflashed the Crazyflie, but the wifi streaming example does not appear on my wifi, so I cannot connect. I am using the latest information and have done all the required steps. Could you let me know what th...

Hi Marcus
I fixed the error, had to run docker pull bitcraze/aideck and is now good.
Thank you
Rodrigo

Hello Marcus I followed the latest aideck examples folder and have tried to run the steps and find that when I try to run the docker script to make the image I get the following error: Docker error response from daemon: failed to create shim : OCI runtime create failed: container_linux.go:380 starti...

Hi
Now we can proceed to the bootloader issue. Could you provide me with the instructions.

Thank you
Rodrigo

Hello Marcus I found the problem and fixed it!!!! It was my fault, as I was trying to flash the GAP8 with the docker code instead of the Nina module, so I did that and now is working!!!!! One thing is that I am getting two images at once, and cannot close windows, is there a command for closing the ...