Search found 6 matches
- Mon Oct 26, 2020 12:53 pm
- Forum: Lighthouse positioning system
- Topic: Request a more detailed explanation on how to flash the lighthouse bootloader
- Replies: 8
- Views: 3133
Re: Request a more detailed explanation on how to flash the lighthouse bootloader
That is correct answer for me. I success flash with -p option. How can I re-protect the flash like this case? I tried to protect flash using python scripts protect_bootloader.py file in scripts polder. But that makes a different effect on flash protection. In this case [make prog ]command work witho...
- Fri Oct 23, 2020 10:33 am
- Forum: Lighthouse positioning system
- Topic: Request a more detailed explanation on how to flash the lighthouse bootloader
- Replies: 8
- Views: 3133
Re: Request a more detailed explanation on how to flash the lighthouse bootloader
HI. arnaud After doing something else for a while, I now have a chance to test. I tried to flash by making an interface board by referring to the circuit you attached. $ make prog iceprog bootloader_multi.bin init.. cdone: high reset.. cdone: high flash ID: 0xEF 0x40 0x14 0x00 file size: 235162 eras...
- Fri Aug 28, 2020 7:18 pm
- Forum: Lighthouse positioning system
- Topic: Factory Firmware Test
- Replies: 1
- Views: 1417
Factory Firmware Test
I received two new Lighthouse Decks earlier this week. Each test was conducted using one base station V1 or V2. The first issue was that when the base station was turned on and the Lighthouse Deck was booted using the factory firmware, the sync was not found as shown below. $ ./tools/print_frame.py ...
- Tue Aug 18, 2020 2:07 pm
- Forum: Lighthouse positioning system
- Topic: Request a more detailed explanation on how to flash the lighthouse bootloader
- Replies: 8
- Views: 3133
Re: Request a more detailed explanation on how to flash the lighthouse bootloader
HI. arnaud I am not sure if I understand you well. Did you solder the 0Ohm resistor or not? You must have them soldered if you want the flashing to work at all. With your kind explanation, I understood and I discovered my carelessness. :oops: :oops: Now I know where the NM 0Ohm resistor is and what ...
- Tue Aug 18, 2020 11:21 am
- Forum: Lighthouse positioning system
- Topic: Request a more detailed explanation on how to flash the lighthouse bootloader
- Replies: 8
- Views: 3133
Re: Request a more detailed explanation on how to flash the lighthouse bootloader
Did you solder the NM 0Ohm resistors/brigdes on the deck in order to connect the lines to the SPI memory? I tried configuring the circuit and flashing according to your advice, but got the same phenomenon. First I tried to force the creset_b pin to GND before doing'make prog' to keep the FPGA in re...
- Mon Aug 17, 2020 6:20 pm
- Forum: Lighthouse positioning system
- Topic: Request a more detailed explanation on how to flash the lighthouse bootloader
- Replies: 8
- Views: 3133
Request a more detailed explanation on how to flash the lighthouse bootloader
My order for the Lighthouse Deck is on December 7, 2019 and the order number is #3808. I remember that this Lighthouse Deck is a relatively early version. Anyway, I followed the bitcraze github below to program Lighthouse Deck's bootloader. If you want to flash the bootloader in the deck, you need t...