Bitcraze Forums

just looking for some confirmation of what model the bat 54 diode is ? in the schematic its noted as d3 to d6. will this http://www.ebay.co.uk/itm/BAT54-X-10-off-DIODE-SCHOTTKY-SOT-23/370568917734?epid=1788302996&hash=item5647a0f2e6:g:rPUAAOxyUXVRD4S1 or this https://www.ebay.co.uk/itm/BAT54ZFIL...

so removed it it spins up fine.... used a turnigy 750 mah baterry that should work with its high c rating... but so far it trys to fly but cant get of the ground .. so im a bit sad and unsure where to go.... i have bought the original mosfets and can replace them back to normal..but in my head it sh...

ok will do
remove it with a mini jump leed acros the diode?
thanks

ok thanks i managed to find one from the rubbish pile... tested and sadly seems there is a problem still... i shorted the bat input..some how after doing big drones and using xt60s and such had no idea some battery manufactures cheange the positon of +n-.so thats what blew the mosfet... now when i p...

like title i blew a pmv31xn on q4 mosfet for the motor..... is it possible to replace with an alternative. as i only seem to be able to find and order one from china... i have loads of old helicotper and cheap drones i found in bins that use the AO3400A mosfet (xorb-48) will that do.? im not so savy...

ok so no need for the caps on the crazyflie 2.0 .using 3.7v 750mah 30c rating should be fine then.

i have already printed a frame so will upload somewhere when tested...thanks

ok and one last question haha... as questions just seem to make more questions... i have also seen that you were able to up the speed it runs the figure of eight how did you do this? making the delay smaller or larger thrust more pitch yaw? if i make a sequence how do i make it quicker?imagine i am ...

ok ok ... how do i get a controller to work with headless? do i just run python3 headless.py -c and plug in a usb controlerr or is it more complicated? how would i set it to use my internal keyboard ? as for python i am new an have no idea how to up the speed of sending commands to 2 hz any help wou...

amazing thanks for all the help... im still getting my head around some things but am still motivated to make a nice simple intro to the flie prob january time when things are less busy... as an idea i found a example of a good explination of firmware....in the link below is a discription of the cod...

well i started programming this year lol so...when im 60 ill get on it cheers...

thanks for reality check

(*_*)