Bitcraze Forums

Well, I suppose you want to keep the possibility to modify the value of the parameter in the RAM as it is now, and just add the permanent storage in the EEPROM for retrieval at startup and for storage of a single value as requested. If that is the case, I think there is little to no modification req...

Hello, I was trying to change the controller gains of the on board attitude and rate controller, but I can't find a way to change it permanently without recompiling and flashing a new firmware. I did it from the "Parameters" tab of the GUI, but when I reboot the Crazyflie I see the old par...

After a good week i recieved the chargers and i started connecting them. Thanks to the schematics (and to marcus for uploading them) i was sure on how to connect them. Basically, just as in your setup, i have just put in parallel all the connectory, leaving space to use the micro-usb connector but a...

Hello, I ordered a bunch of battery charger to charge my spare batteries. I was thinking of connecting them so use just one cable and one power supply to charge all the batteries. Are there the schematics of the charger available to see how i have to connect them? how much current will be needed if ...

Hello, i'm planning to use a swarm of crazyflie 2.0 for my thesis. Since then will be a lot i was looking on how to get more than one to communicate with a single Crazyradio PA. All the other posts are pretty old and since them support for this functionality has been added to the library and the cli...