Search found 3 matches
- Mon May 06, 2013 3:36 am
- Forum: General discussions
- Topic: Desolder/clean motor pads
- Replies: 12
- Views: 17692
Re: Desolder/clean motor pads
Hi again! I just wanted to say a big "Thanks!!" for all the input. Once I got a little support from my daughter to push a wire through as I heated the pad from the other side it was a breeze! Shortly after that and a couple lines of python, we were experimenting to find good hover values. ...
- Thu May 02, 2013 2:43 pm
- Forum: General discussions
- Topic: Desolder/clean motor pads
- Replies: 12
- Views: 17692
Re: Desolder/clean motor pads
Thank you very much for the support!
I'll pick up a pump on the way home so I have it available.
I'll try heating the pad and pushing the wire through first.
Thank you both for the help!
Bob
I'll pick up a pump on the way home so I have it available.
I'll try heating the pad and pushing the wire through first.
Thank you both for the help!
Bob
- Thu May 02, 2013 12:55 am
- Forum: General discussions
- Topic: Desolder/clean motor pads
- Replies: 12
- Views: 17692
Desolder/clean motor pads
OK, I suck at soldering and paying attention... I somehow switched the M1 and M2 wires when I spun the board around. I've removed the wires after a lot of patience but I can't seem to clean the holes to thread the correct wires through. Does anyone have any pointers? I am crazy pumped to get this to...