Bitcraze Forums

Flashed latest firmware, now it works.
I could cry.
@chad, @arnaud thank you so much! =D

I managed to run cfclient 2016.02, but the behavior remains the same: after a day or so without using it initially connects and runs normally, then it shuts down suddenly; it can be turned on again, and the connection is apparently successful (green LED and all), but no actual communication happens....

Thank you, I tried updating cfclient but 2016.02 fails to build (I added an Issue https://github.com/bitcraze/crazyflie-clients-python/issues/241 ) and cfclient 2015.09 fails to run. Since it used to work and I never even tried to re-flash it, I think that this is a hardware issue, not a software on...

Any clues? I have 300$ worth of brick.

Thank you. IMU: LPS25H I2C connection [OK]. EXPBRD: Found 0 memories. EEPROM: I2C connection [OK]. AK8963: Self test [OK]. LPS25H: Self test [OK]. OW: Found 0. SYS: Free heap: 6048 bytes 30 78 42 43 0 50 0 0 0 0 0 0 0 0 0 7D Status 0 IMU: LPS25H I2C connection [OK]. EXPBRD: Found 0 memories. EEPROM:...

It used to work, now when I connect (PA or Bluetooth it's the same) it just does not power any motor or send attitude data. I noticed that a couple of times I power it up, but only M2 turns on. Most other times the boot sequence runs normally, the motors turn in sequence, then the CF stays idle (M2 ...

Thanks Fred, I had mounted ALL the propellers on the wrong side.
It works now!

I followed religiously the instructions at https://www.bitcraze.io/getting-started-with-the-crazyflie-2-0/ I checked the propellers rotation several times (according to https://www.bitcraze.io/wp-content/uploads/2014/09/cf2_props.png ) and they seem fine. Turn on, green led flashes five times quickl...