Bitcraze Forums

Hi Forum,
I'm very new to CF and ROS but very interested to run this code.
Someone achieves to make it run with a CF 2.0?

Some other suggestion apart of all the usefull stuff found in this thread?

I'm sure I will write here along my experiments with this proceed

cheers

husk

It look quite OK to me. When it flies close to the ground turbulence will make it fly away. It needs to come up at least half a meter to get away from the turbulence. Then as it does not have any position control it will drift away slowly due to air movement and sensor reading errors. The sensor re...

I don't think -2.2 and -0.40 is much of an error so then it is most likely mechanical. It could be that one of the motors isn't working as it should. If you from a level and soft surface, like a carpet, max the trust for a short while so it flies up about a meter into the air and then fall down. Ch...

Hi Tobias, and thanks for your reply and this incredible product! Actually when I put CF in a plane surface my pitch and roll values are more than zero (-2,20 and -0,40). In my version of CFClient I don't have the configuration dialog but I can trim pitch and roll from basic flitgh control in Flitgh...

Hi Forum, this is my first post and I'm totally new to CF Yesterday I finally got my hands on a CF 2.0 and after building it I tryed to make it fly. Every thing was very easy but I can't still perform a decent fly. My problem is that my CF tend to fly to one side and not in a vertical line from goun...